Own Ship Position And Time Setting - JRC JHS-800S Instruction Manual

Settings & Registrations

5.2 Own ship position and time setting

Normally, the ship's position and the time are updated automatically if importing GPS information.
But if necessary, input these parameters manually as follows.
The time that is set here is the time for the position information when the ship
is in said position, and is not reflected in the time for the PRE TIME (present
time) in the DATE & TIME (MENU>SETUP) menu.
■ ■
Procedure
1 1 . .
1 .
In the main menu, touch the [SETUP] → [POS/TIME]
buttons.
2 2 . .
2 .
Display the page you want to set with the [<]/[>]
buttons. Show the items you want to set with the [↑]/[↓]
buttons, and then make changes using either the [+]/[ -]
buttons or the [Edit] button.
➢ You can adjust the setting items in the following ranges.
• [1/2] OW N POS
SOURCE: Select how to acquire position
COORD: Select the coordinates from below.
LATITUD:
LONGITUDE: Manually input the longitude.
• [2/2] UTC POS
UTC POS: Input the date acquired from the position
information.
3 3 . .
3 .
Finally, touch the [ ✓ ] button to confirm.
- After the position and the time information are input manually, that information is
Note
not overwritten with an external device, such as a GPS, automatically.
- To be able to do automatic updates with the information input from the GPS or
other navigational equipment after manual input, make GPS the SOURCE.
-
If the position and the time information are not received within 10 minutes after
powering on, or after 10 minutes elapsed since interrupted, the alarm screen
may appear. Further, regardless of either manually or automatically if not
updated the position and the time within 4 hours after the last entry, the alarm
screen also appears.
5-3
CAUTION
information from below.
GPS (GPS or other navigational
equipment)/MAN (manual input)/CL
(not displayed)
NE, NW, SE, SW
Manually input the latitude.