Intercom - JRC JHS-800S Instruction Manual

4.6.4

Intercom

If multiple controllers (NCM -980) are connected, you can use the handset to talk between the main
unit and a controller or between two controllers. While the intercom function is in use, incoming
audio will not be recorded when the squelch is opened .
(1) Calling and talking
■ ■
Procedure
1 1 . .
1 .
Lift the handset from the cradle and then touch the
[MENU]→ [VOICE FUNC]→ [INTCOM] buttons.
➢ The main unit and controllers list is displayed.
➢ The example at right shows that the following controllers
are connected.
- Address 1:
- Address 2:
- Address 3:
- Address 4:
- Address 5:
2 2 . .
2 .
Touch the button of the controller you want to call.
➢ The screen at right is displayed and the intercom call is
started.
➢ Putting the handset on-hook during a call, ends intercom
mode, and returns you to the status display.
➢ Touching the [CANCEL] button during a call, ends
intercom mode, and returns you to the screen in step 1.
Note - If the handset of the recipient is left off-hook,
the call is not started and the screen at right
is displayed. Touching the [FINISH] button at
this point returns you to the screen in step 1 .
.
- If not answered within 30 seconds, the screen
at right is displayed. Then touch the [OK]
button returns you to the screen in step 1.
3 3 . .
3 .
After answered the phone, the screen shown at right
is displayed and enabled to start the communication.
➢ Press PTT key to talk.
➢ To finish the intercom, replace the handset on hook.
➢ Touching the [FINISH] button at this point returns you
to the screen in step 1.
Calling main unit
Station.02
Station.03
Station.04
Not connected
Operation
4-49