Resetting Jobs (Welding Tasks) To The Factory Settings; Resetting A Single Job - EWM Phoenix 404 Progress puls TGD Operating Instructions Manual

Rectifying faults

Resetting JOBs (welding tasks) to the factory settings

7.3 Resetting JOBs (welding tasks) to the factory settings
All customised welding parameters that are stored will be replaced by the factory
settings.
7.3.1

Resetting a single JOB

Display
32
JOB-
LIST
Setting/selection
Reset to factory settings
The RESET will be done after pressing the button.
The menu will be ended when no changes are done after 3 sec.
JOB-number (example)
The shown JOB will be set to ex works.
NOTE
m /m in
Figure 7-1
JOB-
LIST
099-008717-EW501
24.03.2011