Assembly; Unpacking And Checking Contents - Bosch CM10GD Operating/Safety Instructions Manual

2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 14

▶ Unpacking and Checking Contents

Unpacking the Miter Saw – When removing this
tool from packaging materials, reach down to the
two side carry-handle locations and slowly lift until
it clears the package.
gripping any component of the mechanism
support system.
This symbol is placed at various
locations on the tool to warn the user
of pinch-point areas.
Loose Parts - 1 of each shown
10mm Flat Washer
Bevel Lock Lever
6mm Flat Washer
6mm Lock Nut
10 mm Socket Tool
6/4mm Hex Key

Assembly

To avoid severe pinching,
never lift or move this saw by
Workpiece Clamp
Dust Bag
Checking Contents in Package – Open the top of
the package and look for the included loose parts.
Refer to the diagram below.
Some small parts such as the bevel lock lever and
miter lock knob require attachment to the tool
before it is ready for use – See "Attaching Loose
Parts" on page 16.
power source before performing any assembly,
adjustments or repairs.
Check off for each part
14
To avoid possible injury,
always disconnect plug from
Manual
Operating/Safety Instructions
Miter Lock Knob