Crown Molding Angled To Table And Fence; Miter And Bevel Settings For Standard Crown Molding Cuts - Bosch CM10GD Operating/Safety Instructions Manual

2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 51
▶ Crown Molding Angled to Table
and Fence
The preferred method for cutting crown
molding with this saw is with the molding
lying flat on the table.
The advantage to cutting molding angled
against fence is that no bevel setting is
required. Only the miter angle is adjusted.
The maximum crown molding width that can
be cut and angled to table and fence is 5-1/2".
When cutting crown molding in this fashion it
is recommended to purchase and use the
optional Crown Stop Set (see page 61).
Follow these instructions for cutting crown
molding angled to table and fence.
1. Position the molding so the bottom
(decorative part, which is installed against
the wall) is against the fence.
2. For 90° corner, set the miter angle using
chart below. Tighten the miter lock knob.
3. Support crown molding against the fence
(see "Body and Hand Position" on page 32.)
dry run with the saw Off by conducting a
simulated cutting cycle, and observe the
projected path of the saw blade. Keep hands
at least six (6) inches away from the
projected path of the saw blade.

▶ Miter and Bevel Settings for Standard Crown Molding Cuts

(When Workpiece Angled Against Fence)
Assumptions: Molding is milled consistently.
Corner is 90°.
For other corner angles, divide actual
measurement by 2.
Ceiling
52°
Wall
38°
38/52° Crown Molding
38° Spring Angle
Inside
Corner
Saw Operations
Be aware of the path of
the saw blade. Make a
Ceiling
45°
45° Wall
45/45° Crown Molding
45° Spring Angle
Outside
Corner
Refer to Chart
4. Follow the procedures for chop or slide cut
(see pages 39-40).
5. Wait until blade comes to a complete stop
before returning head assembly to the
raised position and/or removing workpiece.
NOTE: Always take a test cut using scrap to
confirm correct angles.
Crown Molding
Angled Against
Fence
Optional
Crown Stop
Figure 57. Crown Molding Angled
to Table and Fence
Fence
Cutting – Angled to Table and Fence
51
Bottom
Edge of
Molding
45° Miter
"
Bottom Edge
Molding Placed
Upside Down
Crown Stop
Table