Bosch CM10GD Operating/Safety Instructions Manual page 12

2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 12
Getting To Know Your Miter Saw
23. Rubber Deflector – Attaches to bottom of chute.
Deflects dust into the chute.
24. Dust Chute – Directs sawdust up and through the
elbow and to the bag.
25. Elbow – Connects the dust chute to the dust bag.
Can be rotated to direct dust.
26. Dust Bag – Has a zipper at the bottom. Bag can be
uncoupled from elbow for emptying.
27. Mechanism Lock Lever – Holds saw in full back
position for chop cuts or fully extended for
transporting.
28. Link Knob – Attaches guard link to the pivot post.
29. Lower Guard Link – Allows for smooth movement
of the lower guard.
30. Clamp – Use to hold the workpiece to the table
and base – insert into clamp post location (item
39).
31. Brush Cap – Keeps motor brushes in position.
Provides access for inspecting and replacing
brushes.
32. Depth Stop Screw – Turn the knob end to adjust
the blade depth for cutting grooves.
33. Depth Stop Plate – Plate can be swung out to limit
the depth of the blade travel.
34. Pivot Post – Provides support for the saw head,
dust collection system and other functional parts.
35. Axial Glide Mechanism – Allows saw to smoothly
slide in and out. Can be locked in full rear or fully
extended positions.
42
33
43
10
41 40
46
36. Bevel Scale and Pointers – Scale is large and
angled - allows user to easily read bevel angles.
Pointer indicates what the current angle is.
37. Bevel Post – Provides rotating support for all
miter saw parts above the table.
38. Bevel Detent Pin (Crown Molding Setting) –
When engaged, it locks the head assembly to the
bevel angle of 33.9° to the left or right.
39. Fence Lock Knob – Secures fence in desired
position.
40. Miter Detent Plate Screws – Four screws
accessible through holes in the miter scale. These
screws are loosened when adjusting position of
the detent plate.
41. Bevel Range Selector Knob – Allows selection of
3 bevel ranges: "0-45° Left", "0-45° Right" or "Max.
Bevel Angle to 47°."
42. Arbor Lock – Press arbor lock button to keep
blade from rotating when loosening or tightening
arbor bolt during blade removal or installation.
43. Head Assembly Lock Pin – Used to lock the head
assembly in the lower position for transporting.
44. Glide Movement Controller – Adjusts to regulate
movement of the glide mechanism.
45. Base Extension Lock Levers – Locks the base
extensions at the desired positions.
46. Crown stop mount holes – For attaching optional
crown stop supports, see page 61.
12
44
32
34
35
36
37
38
39
45
22