Bosch CM10GD Operating/Safety Instructions Manual page 55

2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 55
▶ Crown Molding Auxiliary Fence
Auxiliary Fence - Using an Auxiliary Fence when
cutting Crown molding flat on the table will reduce
splintering of your workpiece and movement of small
cut-off pieces. Remove the saw's sliding fences (see
page 34) before attaching the auxiliary fence.
Build auxiliary fence by following pattern below -
Material: 3/4" x 1-1/2" wood.
Add 4 holes as dimensioned on pattern -or- Add
3-1/16"
Nut (need 4)
Flat Washer (need 4)
Saw Operations
OVERALL HEIGHT = 1-1/2"
7-15/32"
Drill 4 Holes = 5/16" Diameter
Stationary
Saw Base
Fence
Stationary
Saw Base
Fence
holes following the next steps:
1. Cut wood to the outside dimensions shown and
temporarily attach to saw's stationary fence using
two C-clamps.
2. Use 1/4" drill bit to drill first through existing holes
in the rear of the stationary fence and then through
the wood.
3. Remove wood, countersink the front of the wood
and permanently attach to saw's fence with
hardware shown below.
OVERALL LENGTH = 26-1/16"
10-19/32"
5/16"
New Auxiliary Fence
Board: 3/4" Wide x 1-1/2" High
5/16" Hole Through
1/2" Countersink
1/4" Flat Head Machine Screw x 2-1/2" Long
(need 4)
Top of Base
and Table
Note: The Stationary Fence is permanently
attached to the Saw Base (do not remove)
New Auxiliary Fence
(assembled to Miter Saw)
Top of Base
and Table
Figure 61
55
8"
3-1/16"