Multi-Function Input Terminal; 10V Power Supply - Toshiba ETB003Z Instruction Manual

3.2 Multi-function input terminal

Four output terminals can be added. Function is similar to that of the input terminals of
the inverter, so refer to the inverter instruction manual.
Parameter
Title
Input terminal selection 9 (LI1)
f119
Input terminal selection 10 (LI2)
f120
Input terminal selection 11 (LI3)
f121
Input terminal selection 12 (LI4)
f122
f144 * Input terminal 5~12 response time selection
* VF-PS1 does not have this parameter.
Monitor
Refer to the description on status monitor mode of inverter's instruction manual.
The input terminal status can be monitored by the input terminal status parameter
(fe06), and the parameter can be monitor by the serial communication.
fe06
bit No.
Symbol
Note: The LI5 ~ LI8 are the terminal function of the expansion IO card option 2.

3.3 -10V power supply

The frequency command can be input from RX terminal with pulse and negative voltage
using N10(-10V) and PP(+10V) power.
2k ohm
N10 (-10V)
Function
15 14 13 12 11
LI8 LI7 LI6 LI5 LI4
Inverter Terminal
PP (+10)
RX
Option Terminal
Adjustment range
0 - 135
0 - 135
0 - 135
0 - 135
2 - 200ms
10 9 8 7
LI3 LI2 LI1 S4 S3
Potentio meter
Center position: 0V command
Pulse side position: +10V command
Negative side position: -10V command
The recommended wiring cable length is
less than 1.5m with shielded cable.
11
E6581339⑥
Default setting
0
0
0
0
8
6 5 4 3 2
S2 S1 RES ST
1 0
R F