Multi-Function Input Terminal; 10V Power Supply - Toshiba ETB004Z Instruction Manual

3.2. Multi-function input terminal

Four output terminals can be added. Function is similar to that of the input terminals of
the inverter, so refer to the inverter instruction manual.
Parameter
Title
f123 Input terminal selection 13 (LI5)
f124 Input terminal selection 14 (LI6)
f125 Input terminal selection 15 (LI5)
f126 Input terminal selection 16 (LI5)
f145 *Input terminal 13 - 20 response time selection
* VF-PS1 does not have this parameter.
Monitor
Refer to the description on status monitor mode of inverter's instruction manual.
The input terminal status can be monitored by the input terminal status parameter
(fe06), and the parameter can be monitor by the serial communication.
fe06
bit No.
Symbol
Note: The LI1 ~ LI4 are the terminal function of the expansion IO card option 1.

3.3. -10V power supply

The frequency command can be input from RX terminal with pulse and negative voltage
using N10(-10V) and PP(+10V) power.
PP（+10）
2kΩ
N10（-10V）
Function
15 14 13 12 11
LI8 LI7 LI6 LI5 LI4
Inverter Terminal
RX
Option Terminal
Adjustment range
0 - 135
0 - 135
0 - 135
0 - 135
5 - 200ms
10 9 8 7
LI3 LI2 LI1 S4 S3
Potentiometer
Center position: 0V command
Pulse side position: +10V command
Negative side position: -10V command
The recommended wiring cable length is
less than 1.5m with shielded cable.
11
E6581341
Default setting
0
0
0
0
8
6 5 4 3 2
S2 S1 RES ST
1 0
R F