Saving Settings; Step1 Saving Settings Into Memory - Icom ID-51A Basic Instructions

New2001
PROBLEM
Even holding down
DR mode will not appear.
Even holding down
received call sign will not set to
the destination call sign.
A Local area call can be made,
but the Gateway call or desti-
nation station call cannot be
made.
Position data cannot be re-
ceived.
After transmitting, "L" appears
on the LCD.
"DV" and "FM" icons alternately
New2001

SAVING SETTINGS

When "FROM" (Access repeater) and "TO" (Destination) settings
are saved, the settings can be selected by rotating [DIAL].
STEP 1 Saving settings into memory
In the DR mode, select the set-
tings to be saved into memory.
Shows the settings
to be saved.
Hold down [S.MW]
q
1 second to enter the Select
Memory write mode.
37
POSSIBLE CAUSE
, the
, the
received during scanning, the call sign may
not be received correctly. In that case, "--------
" appears and error beeps sound, and a reply
call cannot be made.
D-STAR repeater.
on the Menu screen, but an external GPS re-
ceiver is not connected.
item on the Menu screen.
While receiving through the internet, some
(poor data throughput performance).
While in the DV mode, an FM signal is re-
ceived.
DR mode screen
for
Select Memory write mode
Go to step w
NOTE: DO NOT hold down
[S.MW] for more than
2 seconds. Otherwise the
Beeps
setting contents will be
copied to the VFO.
TROUBLESHOOTING
SOLUTION
on the CD.
CLONING SOFTWARE
transceiver.
rectly received the call sign.
Register your own call sign (MY) on a gate-
way repeater, or confirm the registration of
the call sign.
in the GPS Set item on the Menu screen.
When the transceiver receives corrupted
"L" is displayed, even if it is a Local area call.
there are no FM signals on the original fre-
quency.
w Rotate [DIAL] to select a
programed is selected, the
memory name will not be pro-
grammed.
e Hold down [S.MW] for 1
second to save the settings
into the channel.
mode, the saved memory con-
tents are briefly displayed.
automatically programmed as
the Memory name.
Up to 16 alphanumeric charac-
ters can be programmed for the
memory name.
8
REF.
Sec. 17 of the
Advanced In-
struction PDF
Advanced In-
struction PDF
- —
p. 4
8
—
—
36
New2001 New2001