Table of Contents
Advertisement
ZN‐S1000VE Installation Guide
4. CONNECTIONS
4.1.Connectors
Video connection
Connect the camera to the Video input connectors on the back panel using 75 ohm video
coaxial cables with a BNC connector. Each video channel input among these connections can
be looped to other equipments as CRT monitor through External Video output connector.
Make sure to connect the analog video input before you turn on the encoder.
i
Otherwise, the device must be rebooted to see the normal display if the
camera is NTSC, because the encoder default setting is PAL without a video
Note
connection.
Audio connection
Connect to the audio input device such as a Mic.
Aout
Ain
Audio input range: 0.01/3.3 (Min/Max)
Sensor Input (D/I)
There are two sensor interface types – Voltage Type and Relay Type. The interface type can be
controlled by the software. Before connecting sensors, check driving voltage and output signal
type of the sensor. Since the connection is different according to sensor type, be careful to
connect the sensor.
07A.05
Speaker
Mic
8
Advertisement
Table of Contents
