Diagnostic Error Message Tables; Diagnostic Error Messages - IBM TotalStorage Network Attached Storage 300G User Reference

Diagnostic error message tables

Table 10 describes the error messages that might appear when you run the
diagnostic programs.
Important: If diagnostic error messages appear that are not listed in Table 10,
make sure that your appliance has the latest levels of BIOS, Advanced System
Management Processor, and diagnostics microcode.
Table 10. Diagnostic error messages
Code Function
001 Core system
005 Video port
011 Serial port
014 Parallel port
015 USB interface
020 PCI interface
030 SCSI interface
075 Power supply
Result Text message
Failed Processor board, ECC Test
System board
Processor and system boards
Integrated serial port
Integrated parallel port
Aborted Can not test USB interface while it is in use.
Note: If you have a USB keyboard or mouse
attached, you cannot run the diagnostic program
for the USB interface.
Failed System board
Failed System board
Tab on PCI Hot Swap slot #n is bad
(where n is the number of the failing PCI slot)
Note: For normal operation, the Power LED for
the hot-plug PCI slot will be on and the Attention
Led will be off.
Failed SCSI adapter in slot n failed register/counter/
power test
(where n is the slot number of the failing adapter)
SCSI controller on system board failed
register/counter/power test
Logical drive on system board adapter
Failed Voltage sensed by the system is out of range
Action
Call for service.
1. Turn off the
appliance.
2. Replace the USB
keyboard and
mouse with a
standard keyboard
and mouse.
3. Turn on the
appliance.
4. Run the diagnostic
test again.
Call for service.
Call for service.
Make sure the tab and
latch on hot-plug PCI
slot n are closed
correctly.
If the problem persists,
call for service.
Refer to the information
provided with the
adapter for instructions.
If the problem persists,
call for service.
Call for service.
Call for service.
Appendix D. POST error messages
65