IBM TotalStorage Network Attached Storage 300G User Reference page 72

Table 9. POST error messages (continued)
POST message Description
00019501 Processor 1 is not functioning.
Action: Replace microprocessor 1.
(The microprocessor 1 error LED will be on.)
If the problem persists, call for service.
00019502 Processor 2 is not functioning.
Action: Replace microprocessor 2.
(The microprocessor 2 error LED will be on.)
If the problem persists, call for service.
00019701 Processor 1 failed the built-in self test.
Action: Replace microprocessor 1.
(The microprocessor 1 error LED will be on.)
If the problem persists, call for service.
00019702 Processor 2 failed the built-in self-test.
Action: Replace microprocessor 2.
(The microprocessor 2 error LED will be on.)
If the problem persists, call for service.
00180100 A PCI adapter has requested memory resources that are not available
Action:
1. Make sure that the PCI adapter and all other adapters are set correctly in the
2. If all memory resources are being used, you might need to remove an adapter to make
00180200 A PCI adapter has requested an I/O address that is not available, or the PCI adapter might be
defective.
Action:
1. Make sure that the I/O address for the PCI adapter and all other adapters are set correctly
2. If the I/O port resource settings are correct, the PCI adapter might be defective. Call for
00180300 A PCI adapter has requested a memory address that is not available, or the PCI adapter might
be defective.
Action:
1. Make sure that the memory address for all other adapters are set correctly in the
2. If the memory resource settings are correct, the PCI adapter might be defective. Call for
00180400 A PCI adapter has requested a memory address that is not available.
Action: If all memory addresses are being used, you might need to remove an adapter to
make memory address space available to the PCI adapter. Disabling the adapter BIOS on the
adapter might correct the error. Refer to the documentation provided with the adapter.
60
300G User's Reference
Configuration/Setup Utility program. If the memory resource settings are not correct,
change the settings.
memory available to the PCI adapter. Disabling the adapter BIOS on the adapter might
correct the error. Refer to the documentation provided with the adapter.
in the Configuration/Setup Utility program.
service.
Configuration/Setup Utility program. If the memory resource settings are not correct,
change the settings.
service.