Power Supply Via Pre-Assembled Power Supply Cable; Power Supply Without Pre-Assembled Power Supply Cable - oventrop Regumaq X-25 Operating Instructions Manual

Fresh water station
Hide thumbs Also See for Regumaq X-25:
Table of Contents

Advertisement

Commissioning
7.3.1
Power supply via pre-assembled power
supply cable
A fused shock-proof socket must be available
at the installation site.
f Close the thermal insulation of the station by fi tting
the upper shell.
f Insert the plug of the pre-assembled power cable
into a shock-proof socket.
7.3.2
Power supply without pre-assembled
power supply cable
If the pre-assembled shock-proof plug cannot
be used, the power supply may only be estab-
lished by a qualifi ed electrician.
DANGER
Danger to life due to electric current!
Danger to life due to contact with live compo-
nents.
f Completely disconnect the product from the
power supply.
f Check that no voltage is present.
f Secure the product against switching back
on.
f The product may only be installed in dry
indoor areas.
NOTICE
Damage to electronic components due to
electrostatic discharge!
f Before touching the inside of the housing,
take suitable equipotential bonding mea-
sures. Touch a grounded component, such
as a tap or radiator.
It must be possible to disconnect the product
from the mains at any time.
f Install a switch that can be accessed at any
time. The product must be capable of being
disconnected entirely from the mains via an
additional device with an isolating distance
of least 3 mm and/or with a disconnecting
device (fuse) according to the applicable
installation regulations.
The controller holder in the lower shell is designed in
such a way that you can easily secure the controller in a
convenient position without the need for tools.
30
1. Carefully remove the controller from the lower shell
as shown in Illust. 22
NOTICE
Damage to the electrical lines and con-
nections caused by tensile forces!
Electric lines and/or connections can break if
the tensile forces applied are too strong.
f Ensure that the cables connected to the
controller are not subjected to any tension.
Illust. 22: Removal of the controller from the lower
shell
2. Rotate the controller and secure it in the installation
position as shown in Illust. 23.
"Regumaq X-25"
138112581-V01.10.2019

Advertisement

Table of Contents
loading

Table of Contents