Installing Hardware - Siemens SIMATIC NET PG PROFIBUS CP 5603 Operating Instructions Manual

Hardware installation

4.2 Installing hardware

4.2 Installing hardware
Electrostatic charge
When handling the module, do not touch the connectors or electronic components.
Please keep to the measures for avoiding electrostatic charges (ESD - electrostatic
discharge).
Setting the PCI-104 module address
Every PCI-104 module must be given a module address according to its position. The
module address is set with the address switch (see below).
The module address is set with the address switch as described below:
Module address
1
2
3
4
NOTICE
Module address 4
Module address 4 is not permitted in the SIMATIC Microbox.
NOTICE
Setting the module addresses
Note that all module addresses matching the slot must be set before the device is put into
operation.
16
CAUTION
Switch 1
on
off
on
off
Switch 2
on
on
off
off
Operating Instructions, 08/2016, A5E02146341A-04
Comment
Factory settings
CP 5603