Installing The Network Card - Siemens SIMATIC NET CP 5512 Installation Instructions Manual

2

Installing the Network Card

1. Before you plug the module into your PC or programming
device, read the section of your PC/PG manual covering the
operation of PC CARDs thoroughly and keep to the instruc-
tions.
2. To operate the CP 5512 with Windows 2000 and Windows
XP, at least one of the following software products is requi-
red:
- STEP 7
- SIMATIC NCM PC
- SIMATIC NET PC Software
You will find more detailed installation instructions for each
Software within your Software product.
3. The CP 5512 must be connected to the busadapter before
the CP 5512 is inserted in the PC Cardbus adapter.
4. Make sure that no tensile stress is exerted on the CP 5512
by the connected bus adapter.
Caution
When you remove the CP 5512, make sure that you use the
ejector of the PC card port. Under no circumstances should
you attempt to pull the card out of the PC card slot by the cable
of the bus adapter.
The CP 5512 must only be removed when there is no commu-
nication taking place otherwise this could make it necesary for
you to restart your computer.
CP 5512 Installation Instructions/Product Information
A5E00175148-02
Installing the Network Card
39