Siemens SIMATIC NET PG PROFIBUS CP 5603 Operating Instructions Manual page 18

Hardware installation
4.2 Installing hardware
To install and connect up the CP 5603 follow the steps outlined below:
1. Shut down your PC and disconnected it from the power supply.
2. Open the PC housing as described in the manual accompanying your Microbox.
3. Set the module address on the CP 5603 as described in chapter 4.
4. Insert the CP 5603 into the prepared PCI-104 slot. Make sure that the CP 5603 sits firmly
and uniformly.
5. Take the 4 supplied M3, 15 mm spacing bolts, wrench size 5 mm and screw the CP 5603
to the underlying spacing bolts.
6. Using the screws supplied, screw the Microbox expansion frame for CP 5603 to the
housing of the Microbox PC.
7. Screw the active RS 485 module to the Microbox expansion frame. To do this use the
supplied locking bolts, 4-40 UNC, 8 mm, wrench size 4.5 mm.
8. Close the housing of the PC by screwing the top panel onto the expansion frame.
9. Insert the PROFIBUS cable into the corresponding PROFIBUS socket of the active RS-
485 module.
10.Connect the computer to the power supply again and restart the computer.
18
Operating Instructions, 08/2016, A5E02146341A-04
CP 5603