Siemens SINUMERIK 840D sl Programming Manual page 536

Additional functions
13.2 Check scope of NC language present (STRINGIS)
Scope of NC language
All available language commands and in particular all those not needed and active language
commands are still known for SINUMERIK powerline. The scope of language to be checked
for SINUMERIK solution line depends on the pre-configured machine data and either
includes all known / just the approved options or active functions in the current scope of
NC language.
Scope of NC language Scope of NC language includes:
Return values
Basic information
Coding:
000
100
2xx
y00
y01 to y11
400
Note
During a check with, STRINGIS should no other coding be found, then the corresponding
NC language command can be programmed and 2xx coding applies.
13-4
G codes of all existing G code groups such as G0, G1, G2,
INVCW, POLY, ROT, KONT, SOFT, CUT2D, CDON, RMB, SPATH
DIN or NC addresses such as ADIS, RNDM, SPN, SR , MEAS
NC language functions such as predefined subprograms
TANG(Faxis1..n, Laxis1..n, coupling factor).
NC language procedures (pre-defined procedures with return
value) such as subprogram with parameter transfer GETMDACT.
NC language procedures (pre-defined procedures without return
value) such as deactivate single block suppression SBLOF.
NC key words such as ACN, ACP, AP, RP, DEFINE, SETMS
Machine data $MN general, $MA axial, $MC channel-specific as
well as all setting data $S... and options data $O... .
NC system variables $ in the parts program and synchronized
actions as well as NC computing parameters R.
The return value is coded. The basic information included is
sub-divided into y and existing detailed information into x.
Test result, whether the current configuration includes:
The NCK is not aware of the STRING name.
The STRING name is a language command but cannot be
programmed, i.e. this function is inactive.
The STRING name is a programmable language command , i.e. this
function is active.
Assignment not possible
Value ranges for existing detailed information known.
For NC addresses which do not have xx=01 or xx=10 and are not
G code G or computing parameter R, see comments (1).
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
Job planning