Omron FJ Series Camera Setup Manual page 45

Transport Layer
Control - GigEVi-
sion
Precautions for Correct Use
Do not change any parameters other than those above.
Additional Information
In the FJ-S££££2 series, the packet size is automatically adjusted to an appropriate size ac-
cording to the Ethernet card settings.
6
In Remote Device - User Set Control - User Set Save, click Execute.
7
Close the Tool.
 Initializing camera settings
1
Launch the tool from Start menu - SentechSDK - StViewer.
2
On the Device Selection screen, select the camera for initializing. Click the OK button to close
the Device Selection.
3
In Remote Device - Device Control - Device Reset, click Execute. This will reset the setting to
the factory default.
4
Close the Tool.
Start the application software
1
Connect the dongle of application software to the PC.
The LED of the connected dongle lights up.
2
Launch the application software from the Start Menu - OMRON - FJ-SW.
Precautions for Correct Use
• Install and use either 32-bit or 64-bit software according to your environment.
FJ Series (Camera & Software Vision Package) PC Vision System Camera Setup Guide (Z428-E1)
Item
GEV SCPD 0 to 4294967295
[6000]
(Unit: Tick, FJ-S£
£££2 Camera: 1
[Tick] = 1 [ns])
GEV SCFTD 0 to 4294967295
[0]
(Unit: Tick, FJ-S£
£££2 Camera: 1
[Tick] = 1 [ns])
1 Setup of Camera & Software Vision
Value
[Default]
Set the delay time of packets between.
Set for preventing packet-loss because
of connecting multiple cameras in one
LAN. Set with GEV SCFTD.
Set the delay time to transmit packets.
Set for preventing packet-loss because
of connecting multiple cameras in one
LAN. Set with GEV SCPD.
Description
1-29
1