SMART EQ forfour 2018 Owner's Manual page 83

Table of Contents

Advertisement

do not remove the covers of the high-
R
voltage electrical system components
that are marked with a yellow warning
sticker
do not insert any objects which con-
R
duct electricity into the charging cable
connector or the charging cable socket
G
DANGER
The vehicle's high-voltage electrical sys-
tem is under high voltage. If the charging
process is not performed properly, it
could cause a fire or an electric shock.
There is a risk of fatal injury.
Do not perform the charging process in
the following situations:
at temperatures of over 50 † and below
R
-40 †
in storms
R
if the charging cable is damaged, rus-
R
ted or corroded
if there is moisture on the charging
R
cable connector or charging cable
socket, or your hands are wet
when cleaning the vehicle
R
To avoid hazardous situations, always han-
dle the charging cable correctly before and
after using it:
before using the charging cable for the
R
first time, remove the adhesive tape
which holds the cable together
unwind the charging cable fully before
R
every charging process
there must be no foreign objects in the
R
charging cable connector or on the
charging cable socket
keep the charging cable out of the reach
R
of children and animals. Always store the
charging cable in a safe place, e.g. in the
charging cable bag
Charging the high-voltage battery
The high-voltage battery must not be
charged with a damaged charging cable.
Therefore, always make sure that:
you do not damage the charging cable,
R
e.g. by driving over it, pulling too hard or
as a result of heavy impacts
the charging cable is not twisted, as oth-
R
erwise the charging cable may overheat
and the cable covering may be damaged
the charging cable is not placed in water,
R
fluids or snow
The charging cable must always be used in
the correct manner. In order to ensure the
charging cable is handled correctly,
observe the following:
do not make any changes or modifica-
R
tions to the charging cable
only use the charging cable to charge the
R
high-voltage battery
do not pull out the charging cable con-
R
nector or the charging cable socket dur-
ing the charging process
For safety reasons, only use the charging
cable which is supplied with the vehicle or
has been approved by smart for this vehi-
cle.
Useful information
Method of operation
The vehicle is equipped with a high-volt-
age battery for driving. The high-voltage
battery stores the energy needed to operate
the electric motor and releases it again.
The electric motor uses energy stored in the
high-voltage battery for pulling away and
accelerating.
In overrun mode, kinetic energy is conver-
ted into electrical energy by recuperation
and stored in the high-voltage battery.
In addition to recuperation, the high-volt-
age battery can be charged as follows:
with the suitable charging cable at a
R
mains socket while the vehicle is station-
ary
with the suitable charging cable at a
R
wallbox while the vehicle is stationary
with the suitable charging cable at a
R
charging station while the vehicle is sta-
tionary
81
Z

Advertisement

Table of Contents
loading

Table of Contents