Table of Contents
Advertisement
>> Introduction.
24
You can obtain further information from
any Mercedes-Benz Service Centre.
In the following, you will find the addresses
of radio component manufacturers which,
due to their size or nature, do not allow this
information to be indicated on the equip-
ment.
Tyre pressure monitor sensors: Schrader
Electronics Ltd., 11 Technology Park, Belfast
Road, Antrim BT41 1QS, Northern Ireland
Transponder ring:
Visteon Electronics, 04 Rue Nelson Mandela,
Zone Industrielle Borj Cedria, 2055 Bir El
Bey, Tunisia
Remote Keyless Entry:
Visteon Electronics, 04 Rue Nelson Mandela,
Zone Industrielle Borj Cedria, 2055 Bir El
Bey, Tunisia
Alps Electric Europe GmbH, Ohmstraße 4,
D-85716 Unterschleißheim, Germany
Radio:
Visteon Electronics, 04 Rue Nelson Mandela,
Zone Industrielle Borj Cedria, 2055 Bir El
Bey, Tunisia
Continental Automotive, 1 Rue de Clairefon-
taine, 78120 Rambouillet, France
Mobile communication and telemetry:
Ficosa Internationnal, Gran Via de Carles III
98, 08028 Barcelona, Spain
Radar:
Robert Bosch GmbH, Daimlerstraße 6, 71229
Leonberg, Germany
Windscreen unit:
car2go Group GmbH, Fasanenweg 15-17,
70771 Leinfelden-Echterdingen, Germany
Wireless vehicle components (Mexico)
The following information applies to all
components of the vehicle and the informa-
tion systems and communication devices
integrated into the vehicle which receive
and/or transmit radio waves:
Operation of this device is dependent on
the following two conditions: (1) this device
or this equipment must not cause any
interference, and (2) this device must toler-
ate the reception of interference, including
interference that may cause undesired
operating behaviour.
TIREFIT kit
Copy of the original declaration of conform-
ity:
VERIFICATION OF EMC COMPLIANCE
Verification
GZEM161000740001V
No.:
Applicant:
ITW Global Tire Repair Europe
GmbH
Address of
No. 11 Kuiqing Road, Qingxi
Manufac-
Town, Dongguan City, China.
turer:
Factory:
The same as manufacturer
Address of
The same as manufacturer
Factory:
Product
Air compressor
Description:
Model No:
AEROB-DP
Sufficient samples of the product have been
tested and found to be in conformity with
Test Standards: EN 50498:2010
As shown in the
Test Report
GZEM161000740001
Number(s):
This verification of EMC Compliance has
been granted to the applicant based on the
results of the tests, performed by labora-
tory of SGS-CSTC Standards Technical Serv-
ices Co., Ltd. on the sample of the above-
mentioned product in accordance with the
provisions of the relevant specific stand-
ards under Directive 2014/30/EU. The CE
mark as shown below can be used, under
the responsibility of the manufacturer,
after completion of an EU Declaration of
Conformity and compliance with all rele-
vant EU Directives.
Date:
2016-11-10
Signature: Kobe Jian
Advertisement
Table of Contents
