Dräger EPAS Operating Manual page 12

Follow the steps below to print test results.
1.) Place the Alcotest 7410
® Plus
facing the printer, so that the two lights (READY and ON) inter-
face with the printer window. (To ensure proper transmission,
keep window clean and free from scratches.)
2.) After a few seconds, the printer will begin to print the report.
Note: The date and time stamp indicated on the printout will be
the actual time of the breath test.
3.) Remove the Alcotest 7410
®
turn off the 7410 until the results have been verified.
Additional printouts can be obtained by aligning the 7410 to the
printer as outlined above.
Turning the Alcotest 7410
®
The Alcotest 7410 can be turned off one of two ways after the
® Plus
test results have been displayed.
1.) Press the power button on the Alcotest
the instrument displays "dAt". Double-click the power button
twice to turn the Alcotest 7410
®
2.) Place the Alcotest 7410
® Plus
the EPAS case. The Alcotest
automatically after 5 minutes.
onto the printer with its front side
from the printer. Do not reset or
Plus
Off
Plus
7410 and wait until
Plus
®
off, or
Plus
into the cradle and close the lid of
7410 will power off
® Plus
20
Performing a Screening Test
1.) Remove the Alcotest 7410
®
2.) Ensure that the Alcotest
®
Note: The Alcotest 7410
®
"dAt" mode by pressing the power button once.
3.) Double-click the power button to begin the Screening Test warm-
up procedure. The horn will sound twice and the Alcotest
will go through the sequences detailed below:
The Alcotest 7410 will go through the date sequence,
® Plus
month
followed by the time sequence...
hour
followed by the air blank test:
, indicates that the unit is warming up. Once the Alcotest
7410 is ready for a Screening Test, the display shows
Plus
and the green "READY" light comes on.
from the cradle.
Plus
7410 is on, and in "dAt" mode.
Plus
can be turned on and put in the
Plus
®
day year
minute
21
7410
Plus
®