Table of Contents
Advertisement
Providing a Breath Sample
1.) Attach a mouthpiece, ensuring that the arrows on the mouthpiece
and mouthpiece holder point the same direction. Make sure the
mouthpiece fit is snug against the mouthpiece holder.
2.) Instruct the subject to take a deep breath and blow evenly as long
as the horn sounds.
3.) If the test was successful, the result will automatically be dis-
played on the LCD display. (Display time of the results will vary
depending on the alcohol concentration).
Note: If the subject does not fulfill the volume and/or flow rate
requirements,
insufficient breath sample.
When the instrument recycles to "Scr" and the green "READY" light
comes on, the subject can complete the screening test by providing a
proper breath sample.
All test results are stored in the Alcotest
date, time, and sequential test number.
Printing Test Results
Test results from the Alcotest
7410
®
via the LEDs on the face of the Alcotest
1.) Place the Alcotest
7410
®
Plus
facing the printer, so that the two lights (READY and ON) inter-
face with the printer window. (To ensure proper transmission,
keep window clean and free from scratches.)
2.) After a few seconds, the printer will begin to print the report.
Note: The date and time stamp indicated on the printout will
be the actual time of the breath test.
3.) The Alcotest
7410
can be removed from the printer once the
®
Plus
printing has started. Do not reset or turn off the Alcotest
until the results have been verified as accurate.
Additional printouts can be obtained by aligning the Alcotest
to the printer as outlined above.
will be displayed, indicating an
7410
memory, including
®
Plus
can be transferred and printed
Plus
7410
.
Plus
®
onto the printer with its front side
7410
®
7410
®
22
Additional Screening Test
1.) Press and hold the power button until the results are cleared.
2.) The Alcotest
(data) mode.
3.) From the "dAt" mode, double-click the power button to enter the
Screening Test mode.
Turning the Alcotest
The Alcotest
test results have been displayed.
1.) Press the power button on the Alcotest
the instrument displays "dAt". Double-click the power button
twice to turn the Alcotest
2.) Place the Alcotest
the EPAS case. The Alcotest
automatically after 5 minutes.
Plus
Plus
7410
will automatically return to the "dAt"
®
Plus
7410
Off
®
Plus
7410
can be turned off one of two ways after the
Plus
®
®
7410
off, or
Plus
®
7410
into the cradle and close the lid of
®
Plus
7410
®
Plus
23
7410
and wait until
Plus
will power off
Advertisement
Table of Contents
