Huawei FusionModule1000A20 Installation Manual page 73

Prefabricated all-in-one data center

Hide thumbs Also See for FusionModule1000A20:

Table of Contents

FusionModule1000A20 Prefabricated All-in-One Data

Center

Installation Guide

Context

The ASD power box and batteries inside the pre-fab. module have been installed before

delivery. You only need to connect the reserved cables to the batteries onsite.

Preparations

Tools: Phillips screwdriver

Materials: none

Skill requirement: common technician

Procedure

Step 1 Open the power box using a key.

Step 2 Remove the protective foam from the battery and check whether the battery is intact or leaks.

If the battery is damaged or leaks, contact Huawei technical support to replace the battery.

Step 3 Connect the reserved battery cable.

Distinguish the positive and negative battery terminals when connecting a battery cable.

Figure 6-35 ASD battery wiring diagram

Issue 02 (2020-01-15)

6 Installing Devices Inside the Pre-fab. Module

Table of Contents