Paradyne HOTWIRE 7924 User Manual page 9

About This Guide
Document Purpose and Intended Audience
This guide contains information needed to set up, configure, and operate HotWire
Model 7924-A1 T1 HDSL termination units.
It is expected that readers of this document are central office and/or special
service installation technicians or network engineers who have an understanding
of digital subscriber line systems and High-bit-rate Digital Subscriber Loop
(HDSL) transmission systems plus the deployment of such systems in a
telephone company or private network environment.
Document Summary
7924-A2-GB20-10
PRELIMINARY DRAFT
Section Description
Chapter 1 About HotWire 7924 Termination Units . Describes the
features of each version of the Model 7924 and typical
configurations.
Chapter 2 Installing the Unit . Describes how to install the unit and
make connections.
Chapter 3 Using Terminal and Switchpack Modes. Provides
instructions for connecting a VT100-compatible terminal
user interface. Also describes how to make manual
configuration changes directly on the board hardware.
Chapter 4 Customizing DSX-1-Compatible Units . Provides procedures
for modifying configuration options by using the terminal
interface or DIP switches and jumpers on the board.
Chapter 5 Customizing V.35-Compatible Units . Provides procedures
for modifying configuration options by using the terminal
interface or DIP switches and jumpers on the board.
Chapter 6 Monitoring the Unit. Describes how to monitor unit status,
LEDs, and network statistics. Also describes how to monitor
the status of the unit on the opposite side of the HDSL
connection.
June 1997
v