Starting And Ending Loopbacks; Resetting The Unit - Paradyne HOTWIRE 7924 User Manual

Testing

Starting and Ending Loopbacks

To start or stop a local loopback test from a CO unit, enter 5 at the Command
prompt.
To reset the unit after stopping (disabling) a local loopback, enter 4 at the
Command prompt.
To start or stop a remote loopback test from a CO unit, enter 6 at the Command
prompt.

Resetting the Unit

Enter 4 at the Command prompt to reset the board. This is equivalent to cycling
the power.
If "y" is selected, the Main Menu reappears, the loops go down, and the
FAIL (reset) LED lights.
Pressing any key other than "y" is interpreted as an "n".
7-4
Command 5
Local Loopback is Enabled!
Command 5
Local Loopback is Disabled!
Resetting boards is recommended to ensure payload data
integrity!
Command 6
Remote Loopback is Enabled!
Command 6
Remote Loopback is Disabled!
Command 4
Reset will bring the loops down. Are you sure? (y/n)
Command
June 1997 7924-A2-GB20-10
PRELIMINARY DRAFT