Table of Contents
Advertisement
"Sunrise" Gold
T r i m
This kit includes a gold trim piece for the ash lip
and a gold Sunrise piece for the door.
Referring to the diagram, page 5, note how the
various components of the door system fit together. Lay
the load door face down on a soft surface.
Clean the glass thoroughly using a nonabrasive glass
cleaner. Install the glass gasket around the outer edge of
the front face of the door glass carefully to insure proper
'
sealing.
Note: There' are 4 tabs on the Sunrise. These tabs
have a step on the front side and are flush on the back
side. Place the "Sunrise" in the door so the step side is to
the front.
1
Set the glass pane gently onto the door. Install
the hold-down clips and tighten with bolts as shown on
page 5.
To install ash lip
t r i m ,
simply slide the
~ I + I I
over the
ash lip and into the groove on the trim.
.
1
- - - - -
Gold Door
*
The gold door is assembled and installed the same
as the standard door. Refer to page
5. Be careful not to
scratch the glass and be sure to clean the gold before
starting a fire in the stove.
To install
ash
lip
t r i m ,
simply slide the
t r i m
o v a the
ash lip and into the groove on the trim.
Cleaning Gold
he gold
plated
door and gold sunrise should iever
be buffed or polished.Abrasive clesners and metal pol-
,
ishes yill remove the plating and fherefore sh@d never
be used. If the gold needs to be cleaned, wait until the
a
,
stove is completely cool, then use a sponge, soap and
water to gently remove dirt and stains. Before relight-
ing the stove, remove all soap residue and wipe
dry.
25 P61A-2 Pellet Stove
Advertisement
Table of Contents
