Failure To Upgrade Through Ftp - H3C SecPath F5000-A5 Installation Manual

Failed to write data into storage device, maybe no enough space on device
Symptom 2: The file to be downloaded is not found.
•
File will be transferred in binary mode
Downloading file from remote TFTP server, please wait...
File not found.
Symptom 3: The server IP address or local IP address is incorrect.
•
Can't connect to the remote host
Solution
For symptom 1: Delete some files from the CF card or use a new CF card so enough space is
•
available for the application program.
For symptom 2: Enter the correct file name.
•
For symptom 3: Configure the IP addresses correctly, and make sure the local interface is up and
•
you can successfully ping the TFTP server from the local interface.

Failure to upgrade through FTP

Symptom
Start the firewall, and upgrade the software through FTP. The following problems might occur:
• Symptom 1: The CF card has no enough space.
227 Entering Passive Mode (192,168,1,10,10,204)
150 "xxx" file ready to send (xxx bytes) in ASCII mode
FTP: Error Writing Local File(Screen).
• Symptom 2: The file to be downloaded is not found.
227 Entering Passive Mode (192,168,1,10,10,203)
550 Error: File xxx does not exist
FTP: Error Writing Local File(Screen).
Symptom 3: The server IP address or local IP address is incorrect.
•
FTP: Unrecognized host or wrong IP address!
Solution
For symptom 1: Delete some files from the CF card or use a new CF card so enough space is
•
available for the application program.
For symptom 2: Enter the correct file name.
•
• For symptom 3: Configure the IP addresses correctly, and make sure the local interface is up and
you can successfully ping the FTP server from the local interface.
78