Product Description; Application - Salamander Pumps AccuBoost Series Installation And Warranty Manual

Please read instruction details carefully as they are intended to ensure
this product provides long trouble free service. Failure to install
the unit in accordance with the installation instructions will lead to

1. Product Description

The AccuBoost unpumped range consists of a pressure vessel and integral base. The
AccuBoost pumped range consists of a pressure vessel and an electrically operated pump
attached to the integral base. The pump control reacts to the mains water pressure and
draws water from the mains. In both cases, the amount of available water in the property is
increased as well as helping to stabilise the pressure.

2. Application

AccuBoost products are designed to assist the flow and pressure of the mains water supply
within domestic or small commercial applications. The pressure vessel stores mains cold
water at pressure, which is then released into the system to assist the incoming mains water
when an outlet is opened. AccuBoost is ideal for enhancing the performance of combination
boilers, unvented hot water cylinders, electric showers and mixer showers where there is poor
pressure and/or flow.
Unpumped Units
Unpumped units require an incoming mains water static pressure of 2 Bar/200 kPa or above.
The unpumped models will increase the available flow rate by delivering additional flow
from the pressure vessel. Once the water within the vessel has been depleted, the flow will
continue at the natural mains unassisted flow rate.
Pumped Units
For applications where the flow rate and/or the pressure of the incoming mains water is low
(below 12 L/min and/or less than 2 Bar/200 kPa static pressure), the pumped models will
increase the incoming flow rate up to 12 L/min as well as delivering additional flow from the
pressure vessel. Once the water within the vessel has been depleted, the pump will continue
to deliver 12 L/min at a higher pressure than the incoming mains.
Should the natural flow of the incoming mains exceed 12 L/min, the pump is equipped with a
bypass to enable the mains to fulfill more of the demand or refill the vessel.
The pumped units require a minimum unassisted supply of 2 L/min to operate. The pump is
capable of producing a maximum pressure of 4.0 bar (400 kPa) at closed head.
For more information about the AccuBoost range of products: -
2
invalidation of the warranty.
visit our website
www.salamanderpumps.co.uk
call PumpWise on
0191 516 2002
or visit our e-learning website
http://salamandereschool.co.uk