Toyota VIOS Owner's Manual page 549

548
8-2. Steps to take in an emergency
17
Attach the air release cap to the
end of the hose.
If the air release cap is not
attached, the sealant may leak and
the vehicle may get dirty.
Temporarily store the bottle in the trunk while it is connected to the
compressor.
To spread the liquid sealant evenly within the tire, immediately drive
safely for about 5 km (3 miles) below 80 km/h (50 mph).
After driving, stop your vehicle
in a safe place on a hard, flat
surface
repair kit.
Remove the air release cap from
the hose before reconnecting the
hose.
Turn the compressor switch on and wait for several seconds, then
turn it off. Check the tire inflation pressure.
1
If the tire inflation pressure is
under 130 kPa (1.3 kgf/cm
or bar, 19 psi): The puncture
cannot be repaired. Contact
your Toyota dealer.
2
If the tire inflation pressure is
130 kPa (1.3 kgf/cm
19 psi) or higher, but less
than the specified air pres-
sure: Proceed to step
3
If the tire inflation pressure is the specified air pressure (P. 607):
Proceed to step
VIOS_OM_GE_OM52L06E(TMT)_OM99V20b(TDB)_OM52L61E(TMP)_0D053(IMC)
and reconnect the
2
or bar,
.
.
2