Step 3: Prepare Wirebox And Mount To Wall - Tesla Gen 3 Wall Connector Manual

INSTALLATION

Step 3: Prepare Wirebox and Mount to Wall

1. Use a 1/4 in (6.5 mm) bit to drill two pilot holes into the wirebox that match the locations chosen on
the cardboard mounting template.
Drill bit, 1/4 in (6.5 mm)
Top Entry
2. Attach the wirebox to the mounting location using the included 4 mm hex bit and the two included
wood fastener screws.
NOTE: Type 3R rating is only possible when washers have sealing gaskets. If mounting to alternate
surface (such as a prefabricated pedestal), use alternate fasteners with sealing washers.
NOTE: The wood fastener screws are designed to support the weight of the entire Wall Connector,
cable, and charging handle.
18
Bottom Entry Bottom Left Entry Bottom Right Entry
Gen 3 Wall Connector Manual