Overview The MGate EIP3170 and EIP3270 are 1- and 2-port DF1-to-EtherNet/IP gateways that provide protocol conversions for users who need to connect Rockwell Automation PLCs to an EtherNet/IP network. The MGate EIP3000 Series products support up to 8 EtherNet/IP clients and 8 EtherNet/IP servers simultaneously.
Release the reset button when the Ready LED stops blinking. Panel Layouts The MGate EIP3170 has a male DB9 port and a terminal block for connecting to serial devices. The MGate EIP3270 has two DB9 connectors for connecting to serial devices.
STEP 4: Connect the power source to power input. Wall or Cabinet Mounting Mounting the MGate EIP3170/3270 on to a wall requires two screws. The heads of the screws should be 5 to 7 mm in diameter, the shafts should be 3 to 4 mm in diameter, and the length of the screws should be more than 10.5 mm.
Serial Port (Male DB9) RS-232 – RS-422 (Terminal Block) Pinouts RS-422 TxD+(B) TxD-(A) RxD+(B) RxD-(A) Power Input and Relay Output Pinouts Shielded DC Power Relay Relay Power Power Power Ground Input 1 output output Input 1 Input 2 Input 2 Environmental Specifications Power Requirements Power Input...
Page 6
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. ATEX and IECEx Information EIP3170/ EIP3270 Serial 1.
Need help?
Do you have a question about the MGate EIP3170 and is the answer not in the manual?
Questions and answers