PaloAlto Networks PA-7000 Series Hardware Reference Manual page 83

hardware. For details on the ESD port location, see
Front Panel (AC).
STEP 3 | Power off the chassis and disconnect the power cords.
STEP 4 | Remove the LFC from the antistatic bag and slide it into the log card slot (slot 8 on a PA-7050
firewall or slot 7 on a PA-7080 firewall) ensuring that the handles are in the open position.
When the card is about 1/4-inch from being fully inserted, adjust the levers to align with the
chassis and then close the levers to seat the card in place.
The LFC has a double lever on each side of the card. After loosening the thumb screws,
you must pull the inner lever toward you to unlock the outer lever from the chassis and
then pull the outer lever to release the card from the chassis. When installing the card,
when you push the outer lever in, it will lock the inner lever.
The left and right inner levers have a micro-switch that will power off the card as soon as
they are pulled to unlock the outer lever.
PA-7000 SERIES FIREWALL HARDWARE REFERENCE | PA-7000 Series Firewall Installation
PA-7050 Front Panel (AC) or PA-7080
83
2019 Palo Alto Networks, Inc.
©