Install The Pa-7080 Firewall Emi Filter - PaloAlto Networks PA-7000 Series Hardware Reference Manual

Install the PA-7080 Firewall EMI Filter

The PA-7080 Electromagnetic Interference (EMI) filter (PAN-PA-7080-EMI-FLTR) reduces EMI emissions
and is required when you install the following hardware components:
• PA-7000 100G NPC
• PA-7080-SMC-B
• PA-7000-LFC-A
If the PA-7080 firewall has a serial number greater than 10,000, then the built-in internal EMI
filter is already installed and this external EMI filter is not required. Inspect the back vents to
determine if the internal filter is installed.
Slide the top tabs of the EMI filter into the top row of air vents on the back of the firewall and
STEP 1 |
then lower the filter until it is flush with the chassis.
Secure the filter to the chassis using the four captive screws (two screws on each side).
STEP 2 |
110
PA-7000 SERIES FIREWALL HARDWARE REFERENCE | PA-7000 Series Firewall Installation