Table of Contents
Advertisement
Connect a Target Drive to the SATA HDD Target Port on
3.
the Duplicator.
SATA HDD/SSD: Connect the Short SATA Cable (included)
•
to the SATA HDD Target Port and the other end to the
SATA Port on the SATA HDD/SSD.
PC Installation: Connect the Long SATA Cable (included)
•
to the SATA HDD Target Port and the other end to the
SATA Port on a SATA HDD/SSD installed in a PC.
eSATA HDD/SSD Enclosure or Docking Station: Connect
•
the eSATA + 12V Power Cable (included) or eSATA+5V
Power Cable (included) to the SATA HDD Target Port and
the other end to a SATA Port on an Enclosure or Docking
Station.
Note: The Target Drive can be a drive you intend to make
an exact copy of, or an Image drive containing several hard
drive images.
For drive protection and heat insolation, place the Source
4.
Drive on an HDD Pad and place the second HDD Pad on
the top of the Source Drive. Then place the Target Drive on
the HDD Pad on top of the Source Drive.
Move the Power Switch on the Duplicator to the On
5.
position. The Duplicator is now ready to use.
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
8
Advertisement
Table of Contents
