StarTech.com SU2DUPERA11 Quick Start Manual

Quick-start guide
Standalone Drive Duplicator and Eraser for USB Flash Drives and 2.5"/3.5" SATA SSDs /HDDs
SU2DUPERA11
Important: Read and understand the entire manual before
you use this product, and follow the instructions as they are
outlined in the manual.
Failure to do so might result in property damage or device
failure.
System requirements are subject to change. For the latest
requirements, please visit www.StarTech.com/SU2DUPERA11.

Product diagram

USB target LEDs
LCD display
SATA source LEDs
USB source LEDs
USB source
port
SATA source port

Package contents

• 1 x SATA/USB duplicator and eraser
• 1 x universal power adapter (NA/JP, UK, EU, AU)
• 2 x drive-connector cables
• 2 x drive pads
• 1 x quick-start guide
For the latest information, technical specifications, and support for
this product, please visit www.StarTech.com/SU2DUPERA11.
USB target port
SATA target
port
SATA
target LEDs
Exit button
OK button
Menu navigation
buttons
Power switch
Power jack
*actual product may vary from photos
Erase and copy modes
The SU2DUPERA11 supports five erase modes and four copy modes.
Mode Definition
Erase modes
Quick erase
Full erase
DoD 5220.22-M erase
DoD 5220.22-M erase
and compare
Secure erase
Copy modes
Copy system and files Only the data area of the source drive is
Copy all partitions All of the partitions and data, including
blank partitions, are copied. Blank space
Copy the whole drive
Copy a percentage
About copying drives
You can use the SU2DUPERA11 to copy SATA drives in any of the
following configurations:
• SATA drive to SATA drive
• SATA drive to USB drive
• USB drive to USB drive
• USB drive to SATA drive
Copy a SATA or USB drive
Note: You should avoid plugging SATA drives directly into the
SU2DUPERA11, as it puts undue strain on the device connectors. Use
the drive-connector cables instead.
Warning! Make sure that the storage capacity of the target drive
is larger than or equal to the storage capacity of the source drive.
Otherwise, you will get an error when you try to copy your drive.
Warning! After you begin copying a drive, don't disconnect either
drive or interrupt the process before it has finished. Doing so might
result in damage to the drive or lost data.
The partition table is quickly erased.
The entire drive is erased.
A three-pass overwrite based on
DoD 5220.22-M specifications
is completed.
A three-pass overwrite based on
DoD 5220.22-M specifications
is completed and compared.
The ATA Secure Erase feature of the
drive is executed.
Note: The Secure Erase feature isn't
supported on USB drives.
copied and the empty space
isn't copied.
and nonpartition space isn't copied.
The entire drive is copied, including
empty space.
A specified percentage range of the
drive is copied.
Manual Revision: 10/24/2016