Table of Contents
Advertisement
Using your Baumatic Cooker Hood:
To use your cooker hood:
1) Make sure it has been properly installed by a suitably
qualified person.
2) Find the CONTROL PANEL. It is located on the right hand
side of the hood, at the front of the canopy.
3) The CONTROL PANEL contains switches as shown in the
Figure below. These perform separate functions. You will
need to understand what both switches do before you
attempt to use your cooker hood.
* Note: The hood should be switched on as soon as you start
cooking.
Control panel functions
1.
Motor OFF
2.
Suction speed selection key (power) 1
3.
Suction speed selection key (power) 2
4.
Suction speed selection key (power) 3
5.
Booster function selection key (power). This lasts 5 minutes,
after which the extractor motor switches off or the hood goes back to
the suction speed (power) previously selected. In order to deselect this
suction speed, press buttons 1 or 2 or 3 or 4.
6.
ON/OFF lights key
7.
Settings and reset filter saturation signals: This lights
up in order to warn you that the grease filter needs maintenance. If it
blinks then maintenance of the carbon filter is required. To reset the
device, please press button 7 and hold for 5 seconds.
In case of possible working anomalies, before contacting service
assistance, disconnect the electrical feed for at least 5 seconds by
pulling out the plug, and then connect it again. If malfunction
continues, contact the Baumatic Service Department on (0118) 933
6911.
8
Advertisement
Table of Contents
