The Carbon Filter Saturation Signalling Device - Baumatic AS35SS Instruction Manual

THE CARBON FILTER SATURATION SIGNALLING DEVICE

If you are using your cooker hood in recirculation mode then it is
necessary to fit a charcoal filter (see page 17 for an explanation of
recirculation and extractor modes).
Your appliance is fitted with a device that will advise you when the
carbon filter is saturated with fat, and needs to be either cleaned or
replaced.
The Carbon Filter Saturation Signalling Device will not be operational
when you first install the appliance. Once the installation of the cooker
hood is complete, it will be necessary for you to turn the device on.
• TURNING THE SIGNALLING DEVICE ON
Press key 1 (motor off) and then press and hold down key 7. Whilst
still holding down key 7, you should press key 5.
At this point key 7 should light up in order to tell you that the
saturation device has been switched on.
• TURNING THE SIGNALLING DEVICE OFF
Repeat the above procedure to turn the saturation device off.
• CHECKING THE STATUS OF THE SIGNALLING DEVICE
Briefly press key 7, if it lights up for a few seconds then the signalling
device is switched on. If key 7 does not light up, then the signalling
device is not activated.
13