General Assembly Instructions - Vacmaster VBVA1010PF Operator's Manual

Wet/dry vacuum, 10 gallon
Hide thumbs Also See for VBVA1010PF:
Table of Contents

Advertisement

GENERAL ASSEMBLY INSTRUCTIONS

A Philips head screw driver is required.
1
6
11
WARNING
PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM.
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the power head off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank; make sure you have all contents as listed
on carton content list on page 6 (Fig. 4).
5. Turn the collection tank upside down and insert the four caster feet into the slots on the
collection tank and tighten with supplied screws. Verify that the casters are mounted correctly.
Do not over-tighten screws (Fig. 5).
6. Your vacuum comes ready for dry vacuum cleaning. If the cartridge filter is not installed, refer
to page 14 for installation instructions (Fig. 6).
7. For wet vacuum cleaning, remove the cartridge filter, install the supplied foam wet filter (Fig. 7).
See page 15 for the foam wet filter installation instructions.
8. Place the power head back on the collection tank, aligning the top section with the latches, and
snap into place (Fig. 8 & 9).
9. Insert the locking end of the hose into the vacuum port of the collection tank and turn to lock
into place (Fig. 10).
10. Choose the desired accessory and insert onto the end of the hose or extension wand (Fig. 11).
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the
other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not change the plug in any way. Double insulation
grounded power cord and grounded power supply system.
2
7
: DO NOT PLUG POWER CORD INTO POWER OUTLET. MAKE SURE
3
8
eliminates the need for the three wire
7
4
9
10
5

Advertisement

Table of Contents
loading

Table of Contents