Vacmaster VBVA1010PF Operator's Manual page 13

1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Remove the four screws holding the intake shield and lift off the shield (Fig. 2).
3. Remove the foam pad from the blower and clean the foam pad with soapy water and allow to
dry (Fig. 3).
4. Replace the foam pad on to the blower aligning the holes to the screw tabs (Fig. 4).
5. Reinstall the intake shield and the four screws (Fig. 5).
CLEANING THE WET/DRY VAC
To keep your Wet/Dry Vac looking its best, clean the outside with a dampened cloth, then dry with
a clean towel.
To clean the inside of the collection tank:
1. Dump debris out.
2. Wash collection tank thoroughly with warm water and mild soap.
3. Wipe out with dry cloth.
1
STORAGE
Before storing your vac, the collection tank should be emptied and cleaned. The cord should be
wrapped around the handle (Fig. 1). The accessories should be stored as illustrated above so they
can be readily available when needed. Store the wet/dry vacuum indoors.
REPAIRS
Repairs for this wet/dry vacuum should be performed only by qualified service personnel using
only identical replacement parts.
13