Installing & Cleaning Cartridge Filter - Vacmaster VBVA1010PF Operator's Manual

INSTALLING & CLEANING CARTRIDGE
INSTALLING & CLEANING THE SUPPLIED CARTRIDGE FILTER
1
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Remove the power head and place in upside down position.
3. Install the cartridge filter over the filter cage making sure the cage is completely covered
(Fig. 2 & 3).
4. Place the filter retainer on top of the cartridge filter over the raised lip and tighten down by
turning retainer clockwise; do not over-tighten (Fig. 4).
5. Place the power head back onto the collection tank.
REMOVING AND CLEANING CARTRIDGE FILTER
1. Unlock and remove the filter retainer by turning retainer handle counter clockwise.
2. Carefully hold and pull the cartridge filter up for removal (Fig. 5).
3. Clean the cartridge filter by gently tapping or brushing dirt off. Cleaning should not be done
indoors in living areas. For optimal performance a new filter is recommended.
4. Install cleaned or new filter into place as instructed above.
5. Wet filters should be removed and allowed to air dry for 24 hours before installing onto the filter.
FILTER
2 3 4
14
5