Table of Contents
Advertisement
EMPTYING THE COLLECTION TANK
WARNING:
BEFORE REMOVING THE POWER HEAD FROM COLLECTION TANK.
1
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Disconnect the hose from the vacuum (Fig. 2).
3. Undo the latches and remove the power head from the collection tank (Fig. 3). Place power
head on a soft, clean surface upside down.
4. Clear all dirt or debris from the collection tank and hose into a proper waste container (Fig. 4).
5. Clean or replace the filters (Fig. 5).
6. Check the hose, attachments, and power cord to verify that they have not been damaged.
7. Place power head on collection tank and secure latches.
IMPORTANT! Clean or change the filter regularly for best performance. ALWAYS USE DUST
FILTER FOR DRY VACUUMING. If the machine is used without the cartridge filter, the motor will
burn out and the warranty will be voided. Always keep spare dust filters on hand.
NOTICE! The filter included is made of high quality material designed to stop small dust particles.
The filter should be used for dry pick-up only. A dry filter is necessary to pick up dust. If the
dust filter is wet, it will clog quickly and be very difficult to clean. Handle the filter carefully when
removing it for cleaning and replacing it. Check the filters for tears or small holes, a small hole
can let dust pass through and out of the filter. Do not use a filter with holes or tears; replace it
immediately.
CLEANING THE BLOWER INTAKE
After using the blower, examine the bottom of the blower for debris and blockages and remove if
found. To clean the foam pad of the intake:
WARNING:
BEFORE REMOVING THE POWER HEAD FROM THE COLLECTION TANK.
MAINTENANCE
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET
2
2
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET
4
3
3
4
12
5
5
Advertisement
Table of Contents
