Fault Finding Tests 8 ~ 10
Test 8
Using a multimeter set on the DC voltage
scale,
measure
terminal (orange wire) and the black earth
wire on the gas valve body. The following
result should be obtained during the
ignition period:
1.1 ~ 2.1 VDC.
Test 9
Using a multimeter set on the DC voltage
scale,
measure
terminal (green wire) and the black earth
wire on the gas valve body. The following
result should be obtained when the pilot
is alight:
1.1 ~ 2.1 VDC.
Test 10
Using a multimeter set on the DC voltage
scale, measure between SV3 wiring loom
plug green wire and the black earth wire on
the gas valve body. The following result
should be obtained when the pilot is
alight:
1.1 ~ 2.1 VDC.
TM081 Rheem 834 Series Hydroelectric CFGWH Service Instructions
REV: AA Issued: 22/02/17
This document is stored and maintained electronically by Rheem Technical Support. All printed copies are deemed uncontrolled.
between
SV1
wiring
between
SV2
wiring
42