Model Identification; Specifications - Rheem 834 Series Service Instructions Manual

MODEL IDENTIFICATION

The identification numbers are designed to convey detailed information about the water
heater to which it is attached. Model number, serial number and date of manufacture must
be quoted in all correspondence.
Model Number
8 - Rheem
Location
3 – Outdoor
Ignition Type
4 – Internal Battery
Capacity
Nominal litres/minute @ 25 ºC rise
Gas Type
N - Natural
P - Propane
0 – No frost protection

SPECIFICATIONS

Heater Specifications
Specification
Gas Consumption
Electrical
Gas Supply
Water Connections
(1)
Water Pressure
Minimum Starting Flow Rate / Pressure
Pressure Relief Valve Setting
Temperature Setting
Burner Gas
Pressure settings
(3)
IP Rating
(1)
If the water supply pressure exceeds 80% of the maximum water supply pressure, a pressure limiting
valve must be installed.
(2)
Selectable via temperature controller DIP switches 7 & 8. To be performed by suitably qualified persons
only (refer to 'Adjusting the Setpoint Temperature' on page 45).
(3)
Not applicable due to not being connected to an electrical power supply.
TM081 Rheem 834 Series Hydroelectric CFGWH Service Instructions
REV: AA Issued: 22/02/17
This document is stored and maintained electronically by Rheem Technical Support. All printed copies are deemed uncontrolled.
Minimum (MJ/hr)
Maximum (MJ/hr)
Supply
Connection
Min Gas Pressure
Max Gas Pressure
Inlet
Outlet
Minimum
Maximum
(2)
Min Setting (kPa)
Max Setting (kPa)
8 3
834012N0 834012P0
31.2 31.3
99 96
3.7 VDC battery & integral hydro electric generator
R 3/4" BSP Female
1.13 kPa 2.75 kPa
3.5 kPa 3.5 kPa
R 1/2" BSP Male
R 1/2" BSP Male
150 kPa
800 kPa
3.04 L/min / 64 kPa
850 kPa
45°C, 50°C or 60°C selectable (factory set @ 60°C)
0.080 0.21
0.72 1.85
N/A N/A
4 012 N
834016N0 834016P0
41.5
128 125
1.13 kPa 2.75 kPa
3.5 kPa 3.5 kPa
0.088 0.21
0.74 1.85
N/A N/A
0
43
4