Proxim RangeLAN 802 8520 User Manual page 45

The RangeLAN802 Access Point supports the following MIBs:
MIB-II (RFC 1213)
IEEE 802.1d Bridge MIB (RFC 1493)
Extended Ethernet MIB (RFC 1643)
IEEE 802.11 MIB
Proxim Enterprise MIB
The Proxim Enterprise MIB is supplied in ASN.1 format. It is available for
download on Proxim's Web site at http://www.proxim.com/. The filename is
AP8520.MIB. Follow the instructions in your SNMP management package for
incorporating enterprise-specific MIBs.
Note:
The RangeLAN802 Access Point is manufactured without a default IP
address. In order to SNMP manage the RangeLAN802 Access Point, you must
first assign it a valid IP address for your network using null modem cable
configuration or a BOOTP server.
You may choose to configure the RangeLAN802 Access Point through the menu trees
(in-band or out-of-band) to set SNMP parameters before using an SNMP manager.
Enable/Disable SNMP allows you to enable or disable SNMP management of
the RangeLAN802 Access Point.
The Read-Only SNMP Community parameter specifies a community sup-
ported by the RangeLAN802 Access Point. Actions permitted by this commu-
nity are "read-only" (GET and GET-NEXT). SET attempts using this commu-
nity will result in rejection of the attempt with a general error response and the
generation of an authentication trap (if so enabled).
The Read-Only SNMP Manager IP Address specifies the IP address of the
SNMP manager which is permitted to use the Read-Only SNMP Community.
An address of 0.0.0.0 indicates any manager may use this community.
38