MicroStep SH-HC30 User Manual page 34

Fig. 4-1 Operation flow of initial use or when det ection mode is intended to switch
4.5 Routine Operation Flow
When
ascending
low level,
torch moves up.
When the
descending signal is at low
level, the cutting
moves down
Press the key "Up" on the
operation panel once to have
the set value of height incr eased
by 1
Press the key "Down" on the
operation panel once to have
the set value of height
decreased by 1
LCD indicates the set
value of height
Fig. 4-2 Routi ne Operation Fl ow
PDF 文件使用 "pdfFactory Pro" 试用版本创建
调高器说明书
Flow starts
Power on CNC system
and height controller
auto-detection of "manual
/auto" mode
Yes
Manual?
the manual
signal is at
the cutting
manual
torch
www.fine print.com.cn
No
The cutting torch adjusts its
height automatically as per
the set value of height.
Press the key "Up" on the
operation panel once to
have the
height increased by 1
set value of
Press the key "Down" on the
operation panel once to have
the set value of height
decreased by 1
LCD indicates the actual
height
29