Table of Contents
Advertisement
Scanner Basics
>
Feed selector
C
Separation Roller
D
Pickup Roller
E
Photoelectric device (glass surface)
F
Antistatic brush
Related Information
"Cleaning Inside the Scanner" on page 95
&
"Replacing the Roller" on page 100
&
Feed selector
Changes the position of the feed selector according to the type of the originals to be scanned.
Normal Feed
Manual Feed
Feeds originals separately one by one. This needs to be replaced
when the number of scans exceeds the service life capacity.
Feeds originals. This needs to be replaced when the number of
scans exceeds the service life capacity.
This sensor reads originals. Be careful to keep it clean.
Brush that eliminates static electricity from originals. Be careful not
to touch it. If the brush becomes bent, it cannot eliminate static
electricity, and this may cause the ejected originals to stick to each
other.
Normally set the selector to this position.
Plain papers, Envelopes, plastic cards (without embossing), and Carrier Sheet
can be fed.
Feeds the originals one by one by manual insertion.
Used to scan special originals such as an original folded in half, plastic card
(embossed card), passport carrier sheet, or booklet,
If multiple sheets of originals are loaded, a double feed (feeding multiple
sheets at a time) occurs.
Note:
In the Manual Feed, the double feed detection function is disabled.
15
Advertisement
Table of Contents
