Engine Oil Top Up; Gear Oil - APRILIA SR 150 Manual

Start up the vehicle after pouring oil and tightened oil
dipstick and oil filler plug. Leave it running for a few minutes
and switch it «OFF». After about 5 minutes, check the level
and if necessary top up without exceeding the «MAX» level
index mark.
For top ups and oil replacement, use new oil of the
recommended type.

ENGINE OIL TOP UP

Always check oil level before carrying out
top ups and add oil without exceeding
the MAX level. Engine oil check-up and
ml
top-up should be carried out every 3,000
kms at our Piaggio 2W Authorized
Dealer.
Caution
Used oils contain harmful substances. It is
recommended to perform Oil replacement as per
the prescribed intervals at our Piaggio 2W
Authorized Dealer equipped with oil dispose off
systems that are environmentally friendly.
Warning
Running the engine with insufficient engine oil quantity or
wrong grade of oil may increase wear and tear on the
moving parts and may cause serious damage.
Excessive oil level at top up can lead to scale formation and
vehicle malfunction.

GEAR OIL

Final reduction unit consists of drive pulley shaft, lay shaft
assy and rear wheel shaft. To facilitate their smooth
functioning irrespective load conditions, gear oil is used.
Let the vehicle stall on center stand. Drain out the gear oil by
opening the socket head screw 8 x12 «X – 1 and X - 2» with
sealing washers. Tighten socket head screw «X - 1» with
washer after gear oil drainage. Refill new gear oil from
socket head screw 8 x12 «X - 2» hole till the oil overflows
slightly from the hole. Tighten socket head screw «X - 2»
with washer.
79
Maintenance