Installing The Unit To A Server; Checking The Installation Environment - Fujitsu PRIMERGY LTO3 User Manual

1

Installing the Unit to a Server

This chapter explains how to install this unit to a server.
Install the unit in accordance with the following procedures.
1
Check the installation environment.
"1.1 Checking the Installation Environment"(pg.59)
2
Set jumpers.
"1.2 Setting Jumpers"(pg.60)
3
Install the unit to the server and connect the SCSI cable and the
power cable.
For details, refer to the "User's Guide" in "Document & Tool CD" provided with the server.
For installation, make sure to use the screws and washers provided with this product.
Only one product can be connected to the server. Do not connect other devices to the SCSI
cable where this unit has been connected.
4
Install the required backup software and driver.
"1.3 Installing the Driver"(pg.61)
1.1

Checking the Installation Environment

For details about the server installation environment, refer to "Safety Precautions" and "Start Guide".
This product is susceptible to its installation environment (especially dust) because the data recording
surface is exposed inside the device. The closer to the floor, the higher the dust level is in general, so
it is recommended to install this product away from the floor, such as on a desk. Install this product in
less dusty environments, referring to the "Examples of installation environments to avoid".
Examples of installation environments to avoid
• On the floor.
• High-traffic areas
• Areas close to open doors/windows, especially, where affected by the external environment, such
as sandy dust, car exhaust emissions, etc.
• Areas close to air ventilating ducts (be careful of air conditioners, exhaust fans, etc.)
• Areas affected by cigarette smoke (Do not smoke in the room where this product is installed)
• Areas close to printers and affected by a toner
• Areas close to paper-handling devices, such as copy machines, shredders, or fax machines, that are
affected by paper particles.
• Reconsider the installation location if dust accumulates at the tape slot and around the product
within a few months of installation.
See " Safety" ( pg.55)
1 Installing the Unit to a Server
E
59