Fujitsu PRIMERGY LTO3 User Manual page 68

Manually ejecting a data cartridge
Check that only the Ready LED is on, and press the eject button.
If using backup software to eject the cartridge, select eject. The Ready LED will blink, and the data
cartridge will be rewound and ejected. Wait until the Ready LED stops blinking before starting and
other operations.
Whether the data cartridge is ejected by pressing the eject button or using backup software, it will be
rewound before it is ejected. Therefore it may take up to a maximum of 15 mins to eject the data
cartridge.
CAUTION
Do not press the eject button for more than 10 seconds. The data cartridge will be
forcibly ejected if the eject button is pressed for more than 10 seconds. Use forcible
ejection when a data cartridge cannot be ejected because of an error.
Eject the data cartridge when the drive is not operating (when the Ready LED is turned on).
Depending on the backup software, the cartridge cannot be ejected using the eject button
(NetVault, etc.). In this case, pressing the eject button does not eject the cartridge. Eject the
cartridge using the backup software.
When the server is turned off, the data cartridge cannot be inserted or ejected.
Automatically ejecting a data cartridge
• For BrightStor ARCserve Backup
1. Click the [Options] button in the Backup Manager of the backup job option.
2. Set [Eject Backup Media upon Completion] in the [Operation] tab to "Eject Media".
68
• When the data cartridge is being ejected do not stop it with your finger or push it
back. Also, do not pull out the data cartridge before it is fully ejected. Doing so
may cause device failure.